A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
Matching wear on both cables means both get inspected and typically replaced together.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
This repair sits close to stored spring energy, which is exactly why licensed handling matters here too.
We carry the common cable lengths and gauges for most residential door sizes.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
Repeated slipping points to a drum issue rather than just the cable itself, which we'll inspect.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Ackerman to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Ackerman, MS